Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

how much should fingers widen (-80 to 80)

how far the dove tails stick out of/into the edge (multiples of thickness)

radius used on all four corners (multiples of thickness)

from one middle of a dove tail to another (multiples of thickness)

Hint of how much the flex part should be shortened

width of the gaps in the cuts (multiples of thickness)

width of the pattern perpendicular to the cuts (multiples of thickness)

width of the pattern in direction of the cuts (multiples of thickness)

inner depth in mm (unless outside selected)

inner height in mm (unless outside selected)

treat sizes as outside measurements 🛈

front width (assuming radius == zero) in mm

back width (assuming radius == zero) in mm

radius of front left corner in mm

radius of front right corner in mm

radius of back_right corner in mm

radius of back left corner in mm

number of pieces for outer wall

style of the top and lid

thickness of the material (in mm) 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈

format of resulting file 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

style for inner corners 🛈

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

print surrounding boxes for some structures 🛈